Zipper Pulls

If you’ve ever broken the pull tab on a zipper you have probably been faced with finding a way to replace it. Although paperclips and safety pins work for a little while, they are not a permanent fix. That is why I came up with a better solution.

These zipper pulls are easy to make in just a few minutes. All you need is grosgrain ribbon and a lobster claw clasp with a ring attached. I chose grosgrain ribbon because it is known to be durable, and it is available in many colors. The size of the ribbon I used is 3/8 inch. There are different sizes of ribbon. Just keep in mind that you will need to thread the ribbon through the ring in the clasp.

The lobster claw clasp is easy to use and comes with a ring already attached for the ribbon. There are many sizes of lobster claw clasps. This one measures just over 1 inch and is sturdy enough to use for a zipper. Larger clasps can be too bulky, and smaller clasps are too dainty and could break. I have included three different ways to make a zipper pull using the same methods.

What you need:

  • grosgrain ribbon
  • lobster claw clasp with ring attached
  • scissors
  • measuring tape or ruler

Instructions:

  1. First, measure and cut 5 inches or more of ribbon. Keep in mind that shorter ribbon is harder to work with.
  2. Fold the ribbon in half equally and thread it through the ring.

3. Pull the ends of the ribbon through the loop made by folding the ribbon in half.

4. Continue to pull the ends through until it forms a tight knot.

You’re done!

One other way to tie the ribbon is to make a simple loop. Start by measuring about 8 inches or more of ribbon. Pull the ribbon through the loop. While keeping the ends together, tie them in a loose knot. Gently slide the knot towards the end of the ribbon and tighten the knot.

Lastly, and probably the easiest way to make a zipper pull is to use either of the two methods I have mentioned above and tie the ribbon directly to the zipper.